How to Change a Toilet

Posted by in Home Improvement Tips, on October 31, 2017

https://www.youtube.com/watch?v=OYCYUIhZDCI

Watch the full episode: https://www.thisoldhouse.com/watch/ask-toh-patch-lawn-toilet-grid Ask This Old House plumbing and heating expert Richard Trethewey shows the basics of changing a toilet. Click here to SUBSCRIBE to the official This Old House YouTube channel: http://www.youtube.com/subscription_center?add_user=thisoldhouse Time: 1 hour Cost: $30 Skill Level: Moderate Tools List for Changing a Toilet:
Open ended adjustable wrench
Putty knife
Mini hacksaw Shopping List:
Bucket
Sponge
Drop cloth or plywood
Gloves
Closet bolts, closet nuts, and closet washers
Wax ring
Toilet caps Steps:
1. Shut the water off at the toilet. The shut off valve should be to the left of the toilet.
2. Flush the toilet to drain out as much water as possible. The rest can be removed with a sponge and a bucket.
3. Break the water connection from the hose to the toilet tank. It usually can be loosened with hands alone.
4. Use the open ended adjustable wrench to loosen the closet bolts on both sides of the toilet. Remove the nut and the washer.
5. Use the grips under the toilet to carefully lift the toilet straight up off the bolts. Place the toilet on a piece of plywood or drop cloth to protect the floor.
6. Wearing gloves, remove the wax around the flange using a putty knife.
7. Check to ensure the closet flange is intact. Replace if it is broken.
8. Insert new closet bolts into the flange. Buy ones with plastic tabs on them so they stay in place. It will make it easier to put the toilet back on.
9. Add a new wax ring to the flange.
10. Carefully put the toilet back on the flange and push to set into the wax ring.
11. Add the toilet cap base to the closet bolts on both sides.
12. Put the washer and nut back on the closet bolts. Secure them on both sides with the open-ended adjustable wrench. Take turns securing each side and do not overtighten to prevent damaging the toilet.
13. Use the mini hacksaw to carefully cut the closet bolts close to the nut.
14. Add the toilet cap to the closet bolt. It should snap right into the cap base.
15. Hand tighten the water connection back to the toilet.
16. Turn the water back on. Resources:
Everything Richard used to remove and reinstall the toilet, including the sponge, bucket, wrench, and closet bolts, can be found at home centers and plumbing supply stores. Follow This Old House and Ask This Old House: Facebook: https://www.facebook.com/ThisOldHouse
Twitter: https://twitter.com/thisoldhouse

Pinterest: http://www.pinterest.com/thisoldhouse/
G+: https://plus.google.com/+thisoldhouse/posts
Instagram: http://instagram.com/thisoldhouse
Tumblr: http://thisoldhouse.tumblr.com/ For more stories like this from Bay Area Plumbing Headquarters, bookmark our site.

Leave a Reply

Your email address will not be published. Required fields are marked *