How to Finish a Wood TablePosted by plumbingpros in Home Improvement Tips, on October 14, 2016
Watch the full episode: https://www.youtube.com/watch?v=jNBzKC6aCXo
Wood-finishing expert Bruce Johnson shares his secrets for applying a professional-quality stain and varnish finish. (See below for a shopping list, tools, and steps.)
Click here to SUBSCRIBE to the official This Old House YouTube channel: http://www.youtube.com/subscription_center?add_user=thisoldhouse
Shopping List for How to Finish a Wood Table:
– 120-, 150-, and 180-grit sandpaper, for smoothing the wood
– Oil-based wood conditioner, to pretreat the wood prior to staining
– Cloth, to apply wood conditioner
– Oil-based wood stain, for tinting the wood
– Oil-based polyurethane varnish, applied as a protective topcoat finish
– Stir stick, to stir polyurethane
– 220-grit sandpaper, for sanding the polyurethane
Tools for How to Finish a Wood Table:
– Paintbrushes, to apply wood conditioner, wood stain, and polyurethane varnish
Steps for How to Finish a Wood Table:
1. Lightly hand-sand the wood, always working in the direction of the grain.
2. Start sanding with 120-grit sandpaper and continue with progressively finer sandpaper up to 180 grit.
3. Brush a coat of wood conditioner onto the wood, which will allow the stain to soak in evenly without blotching.
4. After applying the conditioner, wait at least 15 minutes, but no more than 2 hours, before staining.
5. Liberally apply wood stain to the surface using a paintbrush or clean cotton cloth.
6. Allow the stain to soak into the wood for at least 10 minutes.
7. Wipe off all the excess stain with a dry cloth. Wait 8 hours or, if necessary, overnight for the stain to thoroughly dry.
8. Gently stir—never shake—a can of polyurethane varnish.
9. Use a paintbrush to apply an even coat of polyurethane onto the surface. Work the brush back and forth in the direction of the wood grain.
10. After applying the polyurethane, use the tips of the brush’s bristles to very lightly smooth out the finish.
11. Allow the polyurethane to dry overnight, then lightly sand with 220-grit sandpaper.
12. Wipe off the sanding dust with a damp cloth, dry the surface, then brush on a second coat of polyurethane.
Watch new episodes of Ask TOH: http://www.thisoldhouse.com/toh/tv/ask-toh/video/0,,,00.html
Follow This Old House and Ask This Old House:
For more stories like this from Bay Area Plumbing Headquarters, bookmark our site.