How to Upgrade a Bathroom Vanity

Posted by in Home Improvement Tips, on February 4, 2018

https://www.youtube.com/watch?v=RsqQC26uhqc

Watch the full episode: https://www.thisoldhouse.com/watch/ask-toh-rain-chain-vanity-install Ask This Old House plumbing and heating expert Richard Trethewey installs a vanity for homeowners who gave up on it 7 years ago. Click here to SUBSCRIBE to the official This Old House YouTube channel: http://www.youtube.com/subscription_center?add_user=thisoldhouse Cost: $500 and Up Skill Level: Moderate Tools List:
Open ended adjustable wrench
Utility knife
Hammer
Pry bar
Screwdriver Pipe cutter
Hacksaw Measuring tape
Drill
Hole saw
Level Shopping List:
Vanity cabinet
Shut off valves
Countertop
Sink
Silicone caulking
Stain free plumber’s putty
Faucet
Hot and cold water lines
Drain pipe
Pop up drain Steps:
1. Shut the hot and cold water lines off.
2. Disconnect the sink from the P-trap and break the hose connections to the faucet.
3. Use the utility knife to break the seal between the sink and the countertop. Then, carefully pry the sink away from the countertop with a hammer and a pry bar.
4. Remove the screws holding the vanity to the wall and remove the vanity.
5. Shut the water off to the house and cut the hot and cold water lines. Cut the P-trap as well. This will make it so only small holes need to be cut in the back of the new vanity.
6. Measure the distance from the wall to the hot line and cold line. Next, measure the distance from the floor to the hot and cold lines. Transfer these measurements to the back of the vanity and cut out holes with the hole saw.
7. Move the new vanity into place. Check it for level and screw it into the wall.
8. Connect new shut off valves to the hot and cold lines.
9. Flip the countertop upside down and mount the sink to the countertop with silicone caulking and sink clips.
10. Connect the faucet to the countertop using the plumber’s putty and the mounting brackets.
11. Connect the hot and cold water lines to the faucet, then connect the drain pipe and the pop up drain.
12. Once all the connections are made, flip the counter right side up and place it on the cabinet.
13. Make a new P-trap connection with the drain and connect the hot and cold water lines to the shut off valves.
14. Turn the water back on. Resources:
All the tools Richard used for the project, including wrenches, plumber’s putty, and PVC glue, can be found at home centers and plumbing supply stores. The vanity and countertop were custom-ordered by the homeowner. Follow This Old House and Ask This Old House: Facebook: https://www.facebook.com/ThisOldHouse
Twitter: https://twitter.com/thisoldhouse

Pinterest: http://www.pinterest.com/thisoldhouse/
G+: https://plus.google.com/+thisoldhouse/posts
Instagram: http://instagram.com/thisoldhouse
Tumblr: http://thisoldhouse.tumblr.com/ For more stories like this from Bay Area Plumbing Headquarters, bookmark our site.

Leave a Reply

Your email address will not be published. Required fields are marked *